Towbin H, Staehelin T, Gordon J (1979) Electrophoretic transfer of proteins from polyacrylamide gels to nitrocellulose sheets: procedure and some applications.Ni D, Xu P, Gallagher S (2017) Immunoblotting and Immunodetection.Bass JJ, Wilkinson DJ, Rankin D et al (2017) An overview of technical considerations for Western blotting applications to physiological research.Here, we present a rapid Western blot protocol, which combines fast blotting using the iBlot system and fast immunostaining utilizing ReadyTector ® all-in-one solution with the Smart Protein Layers (SPL) approach. To overcome these limitations, stain-free methods were developed allowing the combination of fluorescent standards and a stain-free fluorescence-based visualization of total protein in gels and after transfer to the membrane. Chemiluminescence-based methods are straightforward, but the detected signal does not linearly correlate to protein abundance (from protein amounts >5μg) and have a relatively narrow dynamic range. Conventional colorimetric staining tends to suffer from low sensitivity, limited dynamic range, and low reproducibility. For Western blotting several detection methods are available, e.g., colorimetric, chemiluminescent, radioactive, fluorescent detection. This approach is independent of a single loading control, and precision of quantification and reliability is increased. Another strategy uses total protein normalization where the abundance of the target protein is related to the total protein amount in each lane. However, several studies have already shown that this is not always the case making this approach suboptimal. Usually, normalization of the target protein signal is performed based on housekeeping proteins (e.g., glyceraldehyde 3-phosphate dehydrogenase, ß-actin) with the assumption that those proteins are expressed constitutively at the same level across experiments. Major challenges for the reliable protein quantification by Western blotting are adequate data normalization and stable protein detection. Nevertheless, with the development of fast blotting systems and further development of immunostaining methods, a reduction of the processing time can be achieved. However, the whole procedure is often very time-consuming. It enables detection of a target protein based on the use of specific antibodies. For the quantification of certain proteins of interest within a complex sample, Western blot analysis is the most widely used method.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |